Cisco 7965G Administration Guide

4-29
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Network Configuration
The Network Configuration menu displays device-specific network configuration settings on the phone.
Table 4-17 describes the options in this menu.
Note The phone also has a Network Configuration menu that you access directly from the Settings menu. For
information about the options on that menu, see the “Network Configuration Menu” section on page 4-5.
Table 4-17 Network Configuration Menu Options
Option Description To Change
Load Server Used to optimize installation time for
phone firmware upgrades and offload
the WAN by storing images locally,
negating the need to traverse the WAN
link for each phone's upgrade.
You can set the Load Server to another
TFTP server IP address or name (other
than the TFTP Server 1 or TFTP Server
2) from which the phone firmware can
be retrieved for phone upgrades. When
the Load Server option is set, the phone
contacts the designated server for the
firmware upgrade.
Note The Load Server option allows
you to specify an alternate
TFTP server for phone
upgrades only. The phone
continues to use TFTP Server 1
or TFTP Server 2 to obtain
configuration files. The Load
Server option does not provide
management of the process and
of the files, such as file transfer,
compression, or deletion.
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
RTP Control
Protocol
Indicates whether the phone supports
the Real-Time Control Protocol
(RTCP). Settings include:
• Enabled
• Disabled—default
If this feature is disabled, several call
statistic values display as 0. For
additional information, see the
following sections:
• Call Statistics Screen, page 7-13
• Streaming Statistics, page 8-11
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC