Cisco 7965G Administration Guide

4-19
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Locale Configuration Menu
The Locale Configuration menu displays information about the user locale and the network locale used
by the phone.
Table 4-9 describes the options on this menu.
Table 4-9 Locale Configuration Menu Options
Option Description To Change
User Locale User locale associated with the phone
user. The user locale identifies a set of
detailed information to support users,
including language, font, date and time
formatting, and alphanumeric keyboard
text information.
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
User Locale
Version
Version of the user locale loaded on the
phone.
Display only—Cannot configure.
User Locale Char
Set
Character set that the phone uses for the
user locale.
Display only—Cannot configure.
Network Locale Network locale associated with the
phone user. The network locale
identifies a set of detailed information
that supports the phone in a specific
location, including definitions of the
tones and cadences used by the phone.
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
Network Locale
Version
Version of the network locale loaded
on the phone.
Display only—Cannot configure.
NTP Configuration
(SIP phones only)
Provides access to the NTP
Configuration Menu. For more
information, see the
“NTP
Configuration Menu (SIP Phones
Only)” section on page 4-19
From Cisco Unified Communications
Manager Administration, choose
System > Phone > Phone NTP
Reference.
NTP Configuration Menu (SIP Phones Only)
The NTP Configuration menu displays information about the NTP server and mode configuration used
by SIP phones.
Table 4-10 describes the options on this menu.
Table 4-10 NTP Configuration Menu Options
Option Description To Change
NTP Server 1 IP address of the primary NTP server. Display only—Cannot configure.
NTP Server 2 IP address of the secondary or backup
NTP server.
Display only—Cannot configure.
NTP Mode 1 Primary server mode. Supported modes
are Directed Broadcast and Unicast.
Display only—Cannot configure.
NTP Mode 2 Secondary server mode. Supported
modes are Directed Broadcast and
Unicast.
Display only—Cannot configure.

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC