Cisco 7965G Administration Guide

2-3
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Providing Power to the Phone
You can resolve these issues by isolating the voice traffic onto a separate VLAN. The switch port that
the phone is connected to would be configured to have separate VLANs for carrying:
• Voice traffic to and from the IP phone (auxiliary VLAN, on the Cisco Catalyst 6000 series, for
example)
• Data traffic to and from the PC connected to the switch through the access port of the IP phone
(native VLAN)
Isolating the phones on a separate, auxiliary VLAN improves the quality of the voice traffic and allows
a large number of phones to be added to an existing network where there are not enough IP addresses
for each phone.
For more information, refer to the documentation included with a Cisco switch. You can also access
related documentation at this URL:
http://www.cisco.com/en/US/products/hw/switches/tsd_products_support_category_home.html
Related Topics
• Understanding the Phone Startup Process, page 2-7
• Network Configuration Menu, page 4-5
Providing Power to the Phone
The Cisco Unified IP Phone 7965G and 7945G can be powered with external power or with Power over
Ethernet (PoE). External power is provided through a separate power supply. PoE is provided by a
switch through the Ethernet cable attached to a phone.
Note When you install a phone that is powered with external power, connect the power supply to the phone
and to a power outlet before you connect the Ethernet cable to the phone. When you remove a phone that
is powered with external power, disconnect the Ethernet cable from the phone before you disconnect the
power supply.
The following sections provide more information about powering a phone:
• Power Guidelines, page 2-4
• Phone Power Consumption and Display Brightness, page 2-4
• Power Outage, page 2-5
• Obtaining Additional Information about Power, page 2-5

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC