Cisco 7965G Administration Guide

3-5
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phone 7965G and 7945G Components
of outside sources, for example, electric lights, being near electric motors, large PC monitors. In some
cases, a hum experienced by a user may be reduced or eliminated by using a local power cube. See the
“Safety” section on page 3-2 for more information.
Note Cisco Unified IP Phone 7965G and 7945G support wideband headsets.
Audio Quality Subjective to the User
Beyond the physical, mechanical and technical performance, the audio portion of a headset must sound
good to the user and the party on the far end. Sound is subjective and Cisco cannot guarantee the
performance of any headsets or handsets, but some of the headsets and handsets on the sites listed below
have been reported to perform well on Cisco
Unified IP Phones.
Nevertheless, it is ultimately still the responsibility of customers to test this equipment in their
environments to determine suitable performance.
For information about headsets, refer to:
http://www.vxicorp.com/cisco
http://www.plantronics.com
http://www.jabra.com
Connecting a Headset
To connect a headset to the Cisco Unified IP Phone, plug it into the Headset port on the back of the
phone. Press the Headset button on the phone to place and answer calls using the headset.
You can use the headset with all of the features on the Cisco Unified IP Phone, including the Volume
and Mute buttons. Use these buttons to adjust the ear piece volume and to mute the speech path from the
headset microphone.
Disabling a Headset
You can disable the headset through the Cisco Unified Communications Manager Administration
application. If you do so, you also will disable the speakerphone.
To disable the headset from Cisco Unified Communications Manager Administration, choose Device >
Phone and locate the phone that you want to modify. In the Phone Configuration web page for the phone,
check the Disable Speakerphone and Headset check box.

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC