Cisco 7965G Administration Guide

1-24
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 1 An Overview of the Cisco Unified IP Phone
Overview of Configuring and Installing Cisco Unified IP Phones
4. Monitor the phone startup process. Verifies that phone is
configured properly.
See the “Verifying the
Phone Startup Process”
section on page 3-12.
5. Configure these network settings on
the phone by choosing Settings >
Network Configuration.
To enable DHCP:
• Set DHCP Enabled to Yes
• To use an alternate TFTP server, set
Alternate TFTP Server to Yes
Enter IP address for TFTP Server 1
To disable DHCP:
• Set DHCP Enabled to No
• Enter static IP address for phone
• Enter subnet mask
• Enter default router IP addresses
• Enter domain name where phone
resides
• Set Alternate TFTP Server to Yes
Enter IP address for TFTP Server 1
Using DHCP—The IP address
is automatically assigned and
the Cisco Unified
IP Phone is
directed to a TFTP Server.
Note Consult with the
network administrator
if you need to assign
an alternative TFTP
server instead of using
the TFTP server
assigned by DHCP.
Without DHCP—You must
configure the IP address,
TFTP server, subnet mask,
domain name, and default
router locally on the phone.
See the “Configuring
Startup Network Settings”
section on page 3-13.
See the “Network
Configuration Menu”
section on page 4-5.
6. Set up security on the phone. Provides protection against
data tampering threats and
identity theft of phones.
See the “Configuring
Security on the Cisco
Unified IP Phone” section
on page 3-13.
7. Make calls with the Cisco Unified IP
Phone.
Verifies that the phone and
features work correctly.
Refer to Refer to Cisco
Unified IP Phone 7965G
and 7945G for Cisco
Unified Communications
Manager 6.0 (SCCP and
SIP).
8. Provide information to end users about
how to use their phones and how to
configure their phone options.
Ensures that users have
adequate information to
successfully use their Cisco
Unified
IP Phones.
See Appendix A,
“Providing Information to
Users Via a Website.”
Table 1-7 Checklist for Installing the Cisco Unified IP Phone 7965G and 7945G (continued)
Task Purpose For More Information

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC