Cisco 8821

b) Press More and select Save.
Step 8
Select Security mode.
Step 9
Select the type of security that the access point requires.
Step 10
Set the required security fields using the following table:
DescriptionConfigured FieldSecurity Mode
When the Security mode is set to None, no other fields
are required.
-None
Enter the 40/104 or 64/128 ASCII or Hex WEP key.WEP keyWEP
Enter the 8-63 ASCII or 64 Hex Passphrase.PassphrasePSK
Enter the userid.User IDEAP-FAST
PEAP-GTC
PEAP-MSCHAPV2
Enter the passwordPassword
Select the type of certificate. For more information,
see Certificates, on page 28.
User certificateEAP-TLS
Step 11
Select 802.11 mode and select the required mode.
The mode determines the frequency. If you set the mode to Auto, the phone can use either the 5 GHz or 2.4
GHz frequency, with 5 GHz as the preferred frequency.
Step 12
Select On call power save and press Select to change the setting.
This field should only be set to Disabled if required for troubleshooting.
Step 13
Press More and select Save.
Step 14
Press Power/End Call .
Connect the Phone to the Cisco Unified Communications
Manager
Before You Begin
•
You need the IP address of the Cisco Unified Communications Manager TFTP server.
•
The phone must be configured in the Cisco Unified Communications Manager
•
The phone must be connected to the Wi-Fi network.
Cisco Wireless IP Phone 8821 and 8821-EX Administration Guide for Cisco Unified Communications Manager
68
Configuration on the Phone
Connect the Phone to the Cisco Unified Communications Manager