Cisco 8821

Cisco Wireless IP Phone 8821 and 8821-EX Multi Charger
You can charge 6 phones and 6 spare batteries with the Cisco Wireless IP Phone 8821 and 8821-EX Multi
Charger. The following figure shows the multicharger.
Do not use the multicharger in a hazardous environment.Caution
The multicharger can be placed on a work surface or mounted on a wall with the wall mount kit.
Set Up the Multicharger
The power jack is on the right side of the multicharger.
Procedure
Step 1
Plug the jack end of the power cord into the multicharger.
Step 2
Plug the other end of the power cord into the power adapter.
Step 3
Plug the power adapter into the electrical outlet.
Step 4
Place the multicharger on a stable work surface.
Install the Multicharger Wall Mount Kit
The wall mount kit comes with the following components:
•
bracket
•
package with 5 screws and 5 self-tapping wall anchors
Cisco Wireless IP Phone 8821 and 8821-EX Administration Guide for Cisco Unified Communications Manager
82
Accessories
Cisco Wireless IP Phone 8821 and 8821-EX Multi Charger