Cisco 8961 Quick Guide

2
Choosing a number from the call log
When you enter a number, matching numbers from the call log are
displayed.
Scroll to the number you wish to choose and press the
select button (in the middle of the navigation pad) or press the
Call softkey .
Redial the last dialed number
Press the Redial softkey .
Speed Dialing
Press the Speed Dial key on the left or a line key on the expan-
sion module. Speed dial settings for your telephone can be altered
using the Cisco Unifi ed CM-User Options (see p. 14).
Proceed to “User Options” and select “Device”. Under device name
enter your UDP-Profi le and select “Speed Dial Directory” to store your
Speed Dial numbers.
3
End a call
To end a call you can
® hang up the receiver
or
® press the Release key
or
® press the End Call softkey
or
® press (while lit) the Headset key
or the Speakerphone key .
Answer a call
An incoming call is displayed by the symbol.
To answer you can
® pick up the receiver
or
® press the orange blinking session button on the right.
or
® press the Answer softkey
or
® press the (non-lit) Headset key or the Speakerphone key
or
® press the select button (in the middle of the navigation pad).

Cisco 8961 Specifications

General

Resolution	640 x 480 pixels
Display	5-inch TFT color display
Ethernet	10/100/1000 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE) Class 3
Connectivity	Two-port Gigabit Ethernet switch
Buttons	4 softkeys
USB Port	Yes, supports USB 2.0
Headset Jack	Yes, dedicated headset port
Speakerphone	Full-duplex speakerphone
Codec Support	G.711, G.722, G.729, iLBC
Security	802.1X authentication, TLS, SRTP, HTTPS