Cisco Aironet 1300 Series - Bridge Specifications

CISCO CONFIDENTIAL - First Draft
C-1
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
APPENDIX C
Bridge Specifications
This appendix provides technical specifications for the Cisco Aironet 1300 Series Bridge, power
injector, and power module. Table C-1 lists the technical specifications - TBD.
Table C-1 Bridge, Power Injector, and Power Module Specifications
Category Bridge Power Injector and Power Module
Size Integrated antenna configuration:
8.00 in. W x 8.10 in. H 2.31 in. D
(20.32 cm W x 20.57 cm H 5.87 cm D)
Power injector:
4.62 in. W x 4.76 in. H x 1.07 in. D
(11.74 cm W x 12.09 cm H x 2.72 cm D)
Power module:
TBD in. W x TBD in. H x TBD in. D
TBD cm W x TBD cm H x TBD cm D
LEDs Four LEDs on the back panel: Radio traffic,
Ethernet traffic, bridge status, and Installation and
Alignment Mode
One bi-color power LED on the side panel
Connectors Bottom panel (left to right): Power injector
dual-coax ports (two F-type connectors) and two
reverse-TNC antenna connectors
Side panel (left to right): Two coaxial uplink
F-type connectors, 48-VDC power connector,
RJ-45 connector for 100BASE-T Ethernet,
and a RJ45 serial console port connector
Operating Temperature –22 to 131
o
F (–30 to 55
o
C) Power Injector:
–22 to 131
o
F (–30 to 55
o
C)
Power Module:
32 to 122
o
F (0 to 50
o
C)
Cold Start Temperature TBD
o
F (TBD
o
C) —
Warm-up time
(for full performance)
TBD minutes after cold start —
Non-Operational
Temperature
–40 to 185
o
F (–40 to 85
o
C) Power Injector:
–40 to 158
o
F (–40 to 70
o
C)
Power Module:
-40 to 185
o
F (-40 to 85
o
C)