Cisco Aironet 1300 Series - Bridge LEDs

CISCO CONFIDENTIAL - First Draft
1-5
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Chapter 1 Overview
Key Features
Figure 1-2 Bridge Connector Locations
Bridge LEDs
Four LEDs are located on back of the housing to report installation and alignment conditions, bridge
status, radio activity, and Ethernet activity (see Figure 1-3).
Figure 1-3 Bridge LEDs
1 Ground lug mounting screws 3 Bridge mounting posts
2 Left antenna connector (external antenna
bridge configuration only)
4 Dual-coax Ethernet ports
Primary right antenna connector (external
antenna bridge configuration only)
5 Bridge LEDs
1 Radio LED (R) 3 Ethernet LED (E)
2 Status LED (S) 4 Install LED (I)