Cisco Aironet 1300 Series - Reloading the Bridge Image - TBD; Using the Serial Console Port - TBD

CISCO CONFIDENTIAL - First Draft
8-7
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Chapter 8 Troubleshooting
Reloading the Bridge Image - TBD
Step 4 Enter the bridge password (default Cisco) in the Password field and press Enter. The Summary Status
page appears.
Step 5 Click System Software and the System Software screen appears.
Step 6 Click System Configuration and the System Configuration screen appears.
Step 7 Click Default.
Note If the bridge is configured with a static IP address, the IP address does not change.
Step 8 After the bridge reboots, you must reconfigure the bridge by using the Web browser interface, the Telnet
interface, or IOS commands (refer to the Cisco IOS Software Configuration Guide for Cisco Aironet
Bridges).
Reloading the Bridge Image - TBD
If your bridge has a firmware failure, you must reload the complete bridge image file using the Web
browser interface or by using the serial console port. You can use the browser interface if the bridge
firmware is still fully operational and you want to upgrade the firmware image. However, you can use
the serial console port when the bridge has a corrupt firmware image.
Using the Serial Console Port - TBD
You can use the serial console port on the bridge to reload the bridge image file from an active Trivial
File Transfer Protocol (TFTP) server on a PC connected directly to the power injector Ethernet port.
Note If your bridge experiences a firmware failure or a corrupt firmware image, indicated by three red LEDs,
you must reload the image from a directly connected PC with a TFTP server.
Note This process resets all configuration settings to factory defaults, including passwords, WEP keys, the
bridge IP address, and SSIDs.
Follow the steps below to reload the bridge image file:
Step 1 The PC you intend to use must be configured with a static IP address in the range of 10.0.0.2 to 10.0.0.30.
Step 2 Make sure the PC contains the bridge image file (c1310-k9w7-tar.122-15.JA.tar) in the TFTP server
folder and the TFTP server is activated. For additional information, refer to the “Obtaining the Bridge
Image File” and “Obtaining the TFTP Server Software” sections.
Step 3 Connect the PC to the bridge using a Category 5 Ethernet cable.
Step 4 TBD
Step 5 Wait until the bridge reboots as indicated by all LEDs turning green followed by the Status LED
blinking green.