Cisco Aironet 1300 Series - Power Injector

CISCO CONFIDENTIAL - First Draft
8-4
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Chapter 8 Troubleshooting
Power Injector
The bridge LED blinking error codes are described in Table 8-2.
Power Injector
When the power injector is powered up, it sends a constant discovery tone on the dual-coax cables to the
bridge. When the bridge is connected to the dual-coax cables, it returns the discovery tone to the power
injector. When the power injector detects the returned discovery tone, it applies +48 VDC to the
dual-coax cables to the bridge.
When power is applied to the bridge, the bridge activates the bootloader and begins the POST operations.
The bridge begins to load the IOS image when the Post operations are successfully completed. Upon
successfully loading the IOS image, the bridge initializes and tests the radio.
The power injector LED is shown in Figure 8-2.
Figure 8-2 Power Injector
Table 8-2 Bridge LED Blinking Error Codes
LED
Blinking Codes
Description
First
Digit
Second
Digit
Ethernet 2 1 Ethernet cable problem—verify that the cable is properly
connected and not defective. This error might also indicate a
problem with the Ethernet link. If the cable is connected
properly and not defective, contact technical support for
assistance.
Radio 1 2 Radio not detected—contact technical support for assistance.
1 3 Radio not ready—contact technical support for assistance.
1 4 Radio did not start—contact technical support for assistance.
1 5 Radio failure—contact technical support for assistance.
1 6 Radio did not flash its firmware—contact technical support
for assistance.