Cisco Aironet 1300 Series - Web Browser Interface - TBD; Browser HTTP Interface; Browser TFTP Interface

CISCO CONFIDENTIAL - First Draft
8-8
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Chapter 8 Troubleshooting
Reloading the Bridge Image - TBD
Step 6 After the bridge reboots, you must reconfigure the bridge by using the Web interface, the Telnet
interface, or IOS commands (refer to the Cisco IOS Software Configuration Guide for Cisco Aironet
Bridges).
Note The bridge is configured with the factory default values including the IP address (set to receive an IP
address using DHCP). To obtain the bridge’s new IP address, refer to the “Using the IP Setup Utility”
section on page 5-9.
Web Browser Interface - TBD
You can also use the Web browser interface to reload the bridge image file. The Web browser interface
supports loading the image file using HTTP or TFTP interfaces.
Note Your bridge configuration is not changed when using the browser to reload the image file.
Browser HTTP Interface
The HTTP interface enables you to browse to the bridge image file on your PC and download the image
to the bridge. Follow the instructions below to use the HTTP interface:
Step 1 Open your Internet browser.
Step 2 Enter the bridge’s IP address in the browser address or location line and press Enter. An Enter Network
Password screen appears.
Step 3 Enter your username in the User Name field.
Step 4 Enter the bridge password in the Password field and press Enter. The Summary Status page appears.
Step 5 Click the System Software tab and then click Software Upgrade. The HTTP Upgrade screen appears.
Step 6 Click Browse to locate the image file on your PC.
Step 7 Click Upload.
For additional information, click the Help icon on the Software Upgrade screen.
Browser TFTP Interface
The TFTP interface enables you to use a TFTP server on a network device to load the bridge image file.
Follow the instructions below to use a TFTP server:
Step 1 Open your Internet browser.
Step 2 Enter the bridge’s IP address in the browser address or location line and press Enter. An Enter Network
Password screen appears.
Step 3 Enter your username in the User Name field.