Cisco Aironet 1300 Series - Cisco One-Year Limited Hardware Warranty Terms

CISCO CONFIDENTIAL - First Draft
2-8
Cisco Aironet 1300 Series Bridge Hardware Installation Guide
OL-5048-01
Chapter 2 Installation Overview
Installation Summary
Figure 2-4 Power Module
Figure 2-5 Grounding Block
Installation Summary
Warning Read the installation instructions before you connect the system to its power source.
During the installation of the bridge, you will perform the following operations:
• Connect a user-supplied Category 5 Ethernet cable from your wired LAN network to the power
injector.
• Connect the dual-coax Ethernet cables between the power injector and the grounding block.
Tip You can connect the dual-coax cable connectors to either of the grounding block connectors or
the power injector’s dual-coax ports. The bridge senses the Ethernet signals and automatically
switches internal circuitry to match the cable connections.
1 48-VDC power output cable 3 AC power cord
2 Power module
1
2
3
88829
1 F-type coaxial connectors 2 Ground wire lug
88830
1 1 2