Cisco ATA 190 User Manual

2-4
Cisco ATA 190 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
OL-31821-01
Chapter 2 Preparing to Install the ATA 190 on Your Network
Understanding the ATA 190 Startup Process
For more information about how the phone interacts with the TFTP server, see the Cisco Unified
Communications Manager System Guide,
Cisco TFTP section.
Understanding the ATA 190 Startup Process
When connecting to the VoIP network, the ATA 190 goes through a standard startup process, as described
in
Table 2-1. Depending on your specific network configuration, not all of these process steps may occur
on your ATA 190.
Ta b l e 2-1 ATA 190 Startup Process
Task Purpose Related Topics
1. Obtaining Power.
The ATA 190 uses external power.
See Providing Power to the ATA 190, page 2-2.
2. Loading the Stored Image.
The ATA 190 has non-volatile flash memory in which it
stores firmware images and user-defined preferences. At
startup, the phone runs a bootstrap loader that loads a
phone image stored in flash memory. Using this image, the
phone initializes its software and hardware.
3. Obtaining an IP Address.
If the ATA 190 is using DHCP to obtain an IP address, the
device queries the DHCP server to obtain one. If you are
not using DHCP in your network, you must assign static IP
addresses to each device locally.
4. Requesting the CTL file.
The TFTP server stores the CTL file. This file contains the
certificates necessary for establishing a secure connection
between the device and Cisco Unified
Communications
Manager.
See the Cisco Unified Communications Manager
Security Guide,
Configuring the Cisco CTL
Client.

Cisco ATA 190 Specifications

General

Ports	2 FXS ports
Operating Temperature	32 to 104°F (0 to 40°C)
Network Interface	10/100BASE-T Ethernet
Protocol Support	SIP
Power Supply	5V DC
Voice Codecs	G.711a, G.711u, G.729a, G.729ab
Relative Humidity	10 to 90% noncondensing