3-2
Cisco ATA 190 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
OL-31821-01
Chapter 3 Installing the ATA 190
What the ATA 190 Package Includes
• Do not open or disassemble this product.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
• Use only the power supply that comes with the ATA 190.
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Read the installation instructions before you connect the system to its power source.
Warning
The plug-socket combination must be accessible at all times because it serves as the main
disconnecting device.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
For translated warnings, see the Regulatory Compliance and Safety Information for the Cisco ATA 190
manual.
What the ATA 190 Package Includes
The ATA 190 package contains the following items:
• ATA190 device
• Pointer Card
• 5V Power Adapter with appropriate Country Clip
• Ethernet Cable
Note The ATA 190 is intended for use only with the 5V DC power adapter that comes with the unit.
Installing the ATA 190
To install an ATA 190, follow these steps:
Procedure
Step 1 Connect the power supply to the Cisco DC Adapter port.
Step 2 Connect a straight-through Ethernet cable from the network to the 10/100 SW port on the ATA 190. Each
ATA 190 ships with one Ethernet cable in the box.
To Next Page
Loading...
Need help?
General
