Cisco ATA 190 User Manual

CHAPTER
B-1
Cisco ATA 190 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
OL-31821-01
B
Voice Menu Codes
This section contains information on accessing the Interactive Voice Response (IVR) and a
quick-reference list of the voice configuration menu options for the ATA 190.
Accessing the IVR and Configuring Your Phone Setting
To access the IVR and configure your phone settings, follow these steps:
Note You can change the PIN on the Cisco Unified CM User Options web page.
Procedure
Step 1 To access the IVR, go off-hook on the phone connected to Line 1 and press ****.
The IVR prompts for a password.
Note The ATA 190 allows you to enter only numerical values for password.
Step 2 Enter the PIN by pressing the number keypad, followed by # button.
You are at the IVR main configuration menu.
Step 3 Follow the voice prompts on the IVR. See Table B-1 for information on navigating the IVR.
Step 4 To return to the main configuration menu, press #.
Step 5 To exit the IVR, end the call.
Table B-1 describes the various options in the IVR Configuration Menu
Ta b l e B-1 Navigating the IVR Configuration Menu
Action IVR Code Navigating Notes
Show IP address 110
Configure IP address 111 Availaible in static ip mode only
Show subnet mask 120

Cisco ATA 190 Specifications

General

Ports	2 FXS ports
Operating Temperature	32 to 104°F (0 to 40°C)
Network Interface	10/100BASE-T Ethernet
Protocol Support	SIP
Power Supply	5V DC
Voice Codecs	G.711a, G.711u, G.729a, G.729ab
Relative Humidity	10 to 90% noncondensing