CHAPTER
4-1
Cisco ATA 190 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
OL-31821-01
4
Configuring the ATA 190
Yo u m ust us e Ci s co Unified Communications Manager Administration to configure telephony features
and assign users.
This chapter provides an overview of these configuration and setup procedures. Cisco Unified
Communications Manager documentation provides detailed instructions for these procedures.
Telephony Features Available for the ATA 190
Table 4-1 lists the supported telephony features, many of which you configure by using
Cisco Unified Communications Manager Administration.
Ta b l e 4-1 Telephony Features for the ATA 190
Feature Description Configuration Reference
Audible Message
Waiting Indicator
A stutter tone from the handset, headset, or speakerphone
indicates that a user has one or more new voice messages on
a line.
Note The stutter tone is line-specific. You hear it only
when using the line with the waiting messages.
For more information, refer to:
• Cisco Unified Communications
Manager Administration Guide,
Message Waiting Configuration.
• Cisco Unified Communications
Manager System Guide,
Voice Mail
Connectivity to Cisco Unified
Communications Manager.
cBarge Allows a user to join a non-private call on a shared phone
line. cBarge adds a user to a call and converts it into a
conference, allowing the user and other parties to access
conference features.
The phones support Barge on a shared conference bridge.
For more information, refer to:
• Cisco Unified Communications
Manager Administration Guide,
Cisco Unified IP Phone
Configuration.
• Cisco Unified Communications
Manager System Guide,
Cisco
Unified IP Phones.
• Cisco Unified Communications
Manager Features and Services
Guide, Barge and Privacy.
To Next Page
Loading...
Need help?
General
