Cisco CATALYST 2960

2-80
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
errdisable detect cause
Examples This example shows how to enable error-disabled detection for the link-flap error-disabled cause:
Switch(config)# errdisable detect cause link-flap
You can verify your setting by entering the show errdisable detect privileged EXEC command.
Related Commands Command Description
show errdisable detect Displays error-disabled detection information.
show interfaces status err-disabled Displays interface status or a list of interfaces in the
error-disabled state.