Cisco CATALYST 2960

2-132
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
lacp port-priority
Examples This example shows how to configure the LACP port priority on a port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged
EXEC command.
Related Commands Command Description
channel-group Assigns an Ethernet port to an EtherChannel group.
lacp system-priority Configures the LACP system priority.
show lacp [channel-group-number]
internal
Displays internal information for all channel groups or for
the specified channel group.