EasyManua.ls Logo

Cisco CATALYST 2960

Cisco CATALYST 2960
714 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-218
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
police
Examples This example shows how to configure a policer that drops packets if traffic exceeds 1 Mbps average rate
with a burst size of 20 KB. The DSCPs of incoming packets are trusted, and there is no packet
modification.
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# trust dscp
Switch(config-pmap-c)# police 1000000 20000 exceed-action drop
Switch(config-pmap-c)# exit
This example shows how to configure a policer, which marks down the DSCP values with the values
defined in policed-DSCP map and sends the packet:
Switch(config)# policy-map policy2
Switch(config-pmap)# class class2
Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit
Switch(config-pmap-c)# exit
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands Command Description
class Defines a traffic classification match criteria (through the police, set,
and trust policy-map class configuration commands) for the
specified class-map name.
mls qos map policed-dscp Applies a policed-DSCP map to a DSCP-trusted port.
policy-map Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy.
set Classifies IP traffic by setting a DSCP or IP-precedence value in the
packet.
show policy-map Displays quality of service (QoS) policy maps.
trust Defines a trust state for traffic classified through the class
policy-map configuration or the class-map global configuration
command.

Table of Contents

Other manuals for Cisco CATALYST 2960

Related product manuals