Cisco CATALYST 2960

2-246
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
setup
interface GigabitEthernet0/2
no ip address
!
cluster enable
cluster-name
!
end
Use this configuration? [yes/no]: yes
!
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Related Commands Command Description
show running-config Displays the running configuration on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals
Command Reference, Release 12.2 > File Management Commands
> Configuration File Management Commands.
show version Displays version information for the hardware and firmware.