Cisco CATALYST 2960

2-297
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
show flowcontrol
This is an example of output from the show flowcontrol interface interface-id command:
Switch> show flowcontrol gigabitethernet0/2
Port Send FlowControl Receive FlowControl RxPause TxPause
admin oper admin oper
--------- -------- -------- -------- -------- ------- -------
Gi0/2 desired off off off 0 0
Related Commands Command Description
flowcontrol Sets the receive flow-control state for an interface.