Cisco CATALYST 2960

2-304
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
show interfaces
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
Configured Media: sfp
Active Media: sfp
Attached: 10/100/1000BaseTX SFP-10/100/1000BaseTX
This is an example of output from the show interfaces interface-id transceiver detail command:
Switch# show interfaces gigabitethernet0/3 transceiver detail
ITU Channel not available (Wavelength not available),
Transceiver is externally calibrated.
mA:milliamperes, dBm:decibels (milliwatts), N/A:not applicable.
++:high alarm, +:high warning, -:low warning, -- :low alarm.
A2D readouts (if they differ), are reported in parentheses.
The threshold values are uncalibrated.
High Alarm High Warn Low Warn Low Alarm
Temperature Threshold Threshold Threshold Threshold
Port (Celsius) (Celsius) (Celsius) (Celsius) (Celsius)
------- ------------------ ---------- --------- --------- ---------
Gi0/3 41.5 110.0 103.0 -8.0 -12.0
High Alarm High Warn Low Warn Low Alarm
Voltage Threshold Threshold Threshold Threshold
Port (Volts) (Volts) (Volts) (Volts) (Volts)
------- --------------- ---------- --------- --------- ---------
Gi0/3 3.20 4.00 3.70 3.00 2.95
High Alarm High Warn Low Warn Low Alarm
Current Threshold Threshold Threshold Threshold
Port (milliamperes) (mA) (mA) (mA) (mA)
------- ----------------- ---------- --------- --------- ---------
Gi0/3 31.0 84.0 70.0 4.0 2.0
Optical High Alarm High Warn Low Warn Low Alarm
Transmit Power Threshold Threshold Threshold Threshold
Port (dBm) (dBm) (dBm) (dBm) (dBm)
------- ----------------- ---------- --------- --------- ---------
Gi0/3 -0.0 ( -0.0) -0.0 -0.0 -0.0 -0.0
Optical High Alarm High Warn Low Warn Low Alarm
Receive Power Threshold Threshold Threshold Threshold
Port (dBm) (dBm) (dBm) (dBm) (dBm)
------- ----------------- ---------- --------- --------- ---------
Gi0/3 N/A ( -0.0) -- -0.0 -0.0 -0.0 -0.0
Related Commands Command Description
switchport access Configures a port as a static-access or a dynamic-access port.
switchport block Blocks unknown unicast or multicast traffic on an interface.
switchport backup interface Configures Flex Links, a pair of Layer 2 interfaces that provide mutual
backup.
switchport mode Configures the VLAN membership mode of a port.
switchport protected Isolates unicast, multicast, and broadcast traffic at Layer 2 from other
protected ports on the same switch.
switchport trunk pruning Configures the VLAN pruning-eligible list for ports in trunking mode.