Cisco CATALYST 2960

2-352
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
show mls qos interface
Examples This is an example of output from the show mls qos interface interface-id command when VLAN-based
QoS is enabled:
Switch> show mls qos interface gigabitethernet0/1
GigabitEthernet0/1
trust state:not trusted
trust mode:not trusted
trust enabled flag:ena
COS override:dis
default COS:0
DSCP Mutation Map:Default DSCP Mutation Map
Trust device:none
qos mode:vlan-based
This is an example of output from the show mls qos interface interface-id command when VLAN-based
QoS is disabled:
Switch> show mls qos interface gigabitethernet0/2
GigabitEthernet0/2
trust state:not trusted
trust mode:not trusted
trust enabled flag:ena
COS override:dis
default COS:0
DSCP Mutation Map:Default DSCP Mutation Map
Trust device:none
qos mode:port-based
This is an example of output from the show mls qos interface interface-id buffers command:
Switch> show mls qos interface gigabitethernet0/2 buffers
GigabitEthernet0/2
The port is mapped to qset : 1
The allocations between the queues are : 25 25 25 25
This is an example of output from the show mls qos interface interface-id queueing command. The
egress expedite queue overrides the configured shaped round robin (SRR) weights.
Switch> show mls qos interface gigabitethernet0/2 queueing
GigabitEthernet0/2
Egress Priority Queue :enabled
Shaped queue weights (absolute) : 25 0 0 0
Shared queue weights : 25 25 25 25
The port bandwidth is limited to: 100%
The port is mapped to qset : 1
This is an example of output from the show mls qos interface interface-id statistics command.
Table 2-26 describes the fields in this display.
Switch> show mls qos interface gigabitethernet0/2 statistics
GigabitEthernet0/2
dscp: incoming
-------------------------------
0 - 4 : 4213 0 0 0 0
5 - 9 : 0 0 0 0 0
10 - 14 : 0 0 0 0 0
15 - 19 : 0 0 0 0 0
20 - 24 : 0 0 0 0 0
25 - 29 : 0 0 0 0 0
30 - 34 : 0 0 0 0 0
35 - 39 : 0 0 0 0 0
40 - 44 : 0 0 0 0 0