Cisco CATALYST 2960

2-399
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
show vlan
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs : 45
Number of existing VTP VLANs : 45
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
2 VLAN0200 active Gi0/1, Gi0/2
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2 enet 100002 1500 - - - - - 0 0
Remote SPAN VLAN
----------------
Disabled
Related Commands
BrdgNo Bridge number for the VLAN, if applicable.
Stp Spanning Tree Protocol type used on the VLAN.
BrdgMode Bridging mode for this VLAN—possible values are source-route bridging
(SRB) and source-route transparent (SRT); the default is SRB.
Trans1 Translation bridge 1.
Trans2 Translation bridge 2.
Remote SPAN VLANs Identifies any RSPAN VLANs that have been configured.
Primary/Secondary/
Type/Ports
–
Table 2-29 show vlan Command Output Fields (continued)
Field Description
Command Description
switchport mode Configures the VLAN membership mode of a port.
vlan (global
configuration)
Enables VLAN configuration mode where you can configure VLANs 1 to
4094.
vlan (VLAN
configuration)
Configures VLAN characteristics in the VLAN database. Only available for
normal-range VLANs (VLAN IDs 1 to 1005). Do not enter leading zeros.