Cisco CATALYST 2960

2-410
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
snmp-server enable traps
Note Though visible in the command-line help strings, the cpu [threshold], insertion, and removal keywords
are not supported. The snmp-server enable informs global configuration command is not supported. To
enable the sending of SNMP inform notifications, use the snmp-server enable traps global
configuration command combined with the snmp-server host host-addr informs global configuration
command.
ospf [cisco-specific |
errors | lsa | rate-limit |
retransmit |
state-change]
(Optional) Enable Open Shortest Path First (OSPF) traps. The keywords have
these meanings:
• cisco-specific—(Optional) Enable Cisco-specific traps.
• errors—(Optional) Enable error traps.
• lsa—(Optional) Enable link-state advertisement (LSA) traps.
• rate-limit—(Optional) Enable rate-limit traps.
• retransmit—(Optional) Enable packet-retransmit traps.
• state-change—(Optional) Enable state-change traps.
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
(Optional) Enable Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
• invalid-pim-message—(Optional) Enable invalid PIM message traps.
• neighbor-change—(Optional) Enable PIM neighbor-change traps.
• rp-mapping-change—(Optional) Enable rendezvous point
(RP)-mapping change traps.
port-security
[trap-rate value]
(Optional) Enable port security traps. Use the trap-rate keyword to set the
maximum number of port-security traps sent per second. The range is from
0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
occurrence).
rtr (Optional) Enable SNMP Response Time Reporter traps.
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
(Optional) Enable SNMP traps. The keywords have these meanings:
• authentication—(Optional) Enable authentication trap.
• coldstart—(Optional) Enable cold start trap.
• linkdown—(Optional) Enable linkdown trap.
• linkup—(Optional) Enable linkup trap.
• warmstart—(Optional) Enable warmstart trap.
storm-control
trap-rate value
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per second. The range is 0 to
1000; the default is 0 (no limit is imposed; a trap is sent at every occurrence).
stpx (Optional) Enable SNMP STPX MIB traps.
syslog (Optional) Enable SNMP syslog traps.
tty (Optional) Send TCP connection traps. This is enabled by default.
vlan-membership (Optional) Enable SNMP VLAN membership traps.
vlancreate (Optional) Enable SNMP VLAN-created traps.
vlandelete (Optional) Enable SNMP VLAN-deleted traps.
vtp (Optional) Enable VLAN Trunking Protocol (VTP) traps.