Cisco CATALYST 2960

2-510
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
udld port
• The no udld enable global configuration command followed by the udld {aggressive | enable}
global configuration command to re-enable UDLD globally
• The no udld port interface configuration command followed by the udld port or udld port
aggressive interface configuration command to re-enable UDLD on the specified interface
• The errdisable recovery cause udld and errdisable recovery interval interval global
configuration commands to automatically recover from the UDLD error-disabled state
Examples This example shows how to enable UDLD on an port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# udld port
This example shows how to disable UDLD on a fiber-optic interface despite the setting of the udld
global configuration command:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# no udld port
You can verify your settings by entering the show running-config or the show udld interface privileged
EXEC command.
Related Commands Command Description
show running-config Displays the running configuration on the switch. For syntax
information, select Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
show udld Displays UDLD administrative and operational status for all ports or
the specified port.
udld Enables aggressive or normal mode in UDLD or sets the configurable
message timer time.
udld reset Resets all interfaces shut down by UDLD and permits traffic to again
pass through.