Cisco CATALYST 2960 - Configuring the TFTP Server; Based on the DHCP server configuration, the switch attempts to download one or more configuration files from the TFTP server. If you configured the DHCP server to respond to the switch with all the options required for IP connectivity to the TFTP server, and if you configured the DHCP server with a TFTP server name, address, and configuration filename, the switch attempts to download the specified configuration file from the specified TFTP server.; For the switch to successfully download a configuration file, the TFTP server must contain one or more configuration files in its base directory. The files can include these files:; Configuring the DNS

2-63
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
dot1x
Related Commands Command Description
dot1x guest-vlan Enables and specifies an active VLAN as an IEEE 802.1x guest VLAN.
dot1x port-control Enables manual control of the authorization state of the port.
show dot1x [interface
interface-id]
Displays IEEE 802.1x status for the specified port.