Preface
Organization
xvi
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Organization
This guide is organized into these chapters:
Chapter 1, “Using Express Setup,” provides a quick setup procedure for a
standalone switch.
Chapter 2, “Product Overview,” is a physical and functional overview of the
Catalyst 3560 switch. It describes the switch ports, the standards that they
support, and the switch LEDs.
Chapter 3, “Switch Installation,” contains the procedures on how to power the
switch, how to install the switch in a rack, on a wall, on a table, or on a shelf, and
how to make port connections.
Chapter 4, “Troubleshooting,” describes how to identify and resolve some of the
problems that might arise when installing the switch.
Appendix A, “Technical Specifications,” lists the physical and environmental
specifications for the switches and the regulatory agency approvals.
Appendix B, “Connector and Cable Specifications,” describes the connectors,
cables, and adapters that can be used to connect to the switch.
Appendix C, “Configuring the Switch with the CLI-Based Setup Program,” has
an installation and setup procedure for a standalone switch.
Appendix D, “Translated Safety Warnings,” has translations in various languages
of the warnings in this guide.
Conventions
This document uses these conventions and symbols for notes, cautions, and
warnings:
Note Means reader take note. Notes contain helpful suggestions or references to
materials not contained in this manual.
Caution Means reader be careful. In this situation, you might do something that could
result in equipment damage or loss of data.
To Next Page
Loading...
