Chapter 3 Switch Installation
Installing the Switch
3-22
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Figure 3-12 Attaching the RPS Connector Cover on the Catalyst 3560 Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in Figure 3-13.
Warning
To comply with safety regulations, mount the switches on a wall with the front
panel facing up.
1 Phillips pan-head screws 3 RPS connector
2 RPS connector cover
97926
RATING
100-200V ~
5.0A-2.5A, 50-60 HZ
CONSOLE
DC INPUT
S FOR REMOTE
POW
ER SUPPLY
SPECIFIED IN MANUAL
+12v @7.5A -48 @7.8A
2
3
1
To Next Page
Loading...
