Cisco Catalyst 3560 - Wall Mounting

Chapter 3 Switch Installation
Installing the Switch
3-20
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Attaching the Cable Guide
We recommend attaching the cable guide to prevent the cables from obscuring the
front panel of the switch and the other devices installed in the rack. Use the
supplied black screw shown in Figure 3-10 to attach the cable guide to the left or
right bracket.
Figure 3-10 Attaching the Cable Guide on the Catalyst 3560 Switch
Wall Mounting
To install the switch on a wall, follow the instructions in these procedures:
• Attaching the Brackets to the Switch for Wall Mounting, page 3-20
• Attaching the RPS Connector Cover, page 3-21
• Mounting the Switch on a Wall, page 3-22
Attaching the Brackets to the Switch for Wall Mounting
Figure 3-11 shows how to attach a 19-inch bracket to one side of the switch.
Follow the same steps to attach the second bracket to the opposite side.
1 Cable guide screw
Catalyst 3560
SERIES
PoE-48
SYST
RPS
STAT
DUPLX
SPEED
PoE
MODE
1
2
3
4
1
2
5
6
7
8
9
10
11
12
13
14
15 16
3
4
1
X
2X
15X
1
6X
17
18
21
22
23 24
25 26
27 28
29
30
31
32
19
20
17X
1
8X
31X
32X
33
34
37
38
39
40
41
42
43 44
45
46
47
48
35
36
33X
3
4X
4
7X
4
8X
1
97924