Cisco Catalyst 3560 - Powering On the Switch

1-3
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 1 Using Express Setup
Powering On the Switch
Figure 1-2 Ethernet Cable
Powering On the Switch
Complete these steps to power on the switch:
Step 1 Connect one end of the AC power cord to the power connector on the switch rear
panel, as shown in Figure 1-3.
Figure 1-3 Connecting the Power
Step 2
Connect the other end of the power cable to a grounded AC outlet.
89887
1 Switch 2 AC power cord
RATING
100-200V ~
5.0A-2.5A, 50-60 HZ
CONSOLE
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+12v @
7.5A -48 @7.8A
97908
2
1