Cisco Catalyst 3560 - Connecting to 1000 BASE-T SFP Modules

3-33
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 3 Switch Installation
Connecting to SFP Modules
Figure 3-18 Connecting to a Fiber-Optic SFP Module Port
Step 5
If necessary, reconfigure and restart the switch or target device.
Connecting to 1000BASE-T SFP Modules
Follow these steps to connect a Category 5 cable to a 1000BASE-T SFP module:
Caution To prevent ESD damage, follow your normal board and component handling
procedures.
Step 1 When connecting to servers, workstations, and routers, insert a four twisted-pair,
straight-through cable in the RJ-45 connector. When connecting to switches or
repeaters, insert a four twisted-pair, crossover cable.
1 LC connector
40
41
42
43
44
45
46
47
48
47X
48X
Catalyst 3560
SERIES
PoE-48
1
2
3
4
97931
1