Cisco Catalyst 3560 - Page 94

Chapter 3 Switch Installation
Connecting to SFP Modules
3-34
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Note When connecting to a 1000BASE-T device, be sure to use a four twisted-pair,
Category 5 cable.
Note You can use the mdix auto interface configuration command in the CLI to enable
the Auto-MDIX feature. When the Auto-MDIX feature is enabled, the switch
detects the required cable type for copper Ethernet connections and configures the
interfaces accordingly. Therefore, you can use either a crossover or a
straight-through cable for connections to a copper 10/100 or 1000BASE-T SFP
module port on the switch, regardless of the type of device on the other end of the
connection.
The Auto-MDIX feature is disabled by default. For configuration information for
this feature, refer to the switch software configuration guide or the switch
command reference.
Figure 3-19 Connecting to a 1000BASE-T SFP Module
Step 2
Insert the other cable end in an RJ-45 connector on a target device.
Step 3 Observe the port status LED.
1 RJ-45 connector
40
41
42
43
44
45
46
47
48
47X
48X
Catalyst 3560
SERIES
PoE-48
1
2
3
4
97932
1