Cisco Catalyst 3560 - Diagnosing Problems

4-3
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 4 Troubleshooting
Diagnosing Problems
You can also configure the switch by using the command-line interface (CLI)
setup procedure described in these sections:
• “Starting the Terminal-Emulation Software” section on page C-5
• “Entering the Initial Configuration Information” section on page C-7
Diagnosing Problems
Common switch problems fall into these categories:
• Poor performance
• No connectivity
• Corrupted software
Table 4-1 describes how to detect and resolve these problems.