3-21
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 3 Switch Installation
Installing the Switch
Figure 3-11 Attaching the 19-inch Brackets for Wall Mounting
Attaching the RPS Connector Cover
If you are not using an RPS with your switch, use the two Phillips pan-head
screws to attach the RPS connector cover to the back of the switch, as shown in
Figure 3-12.
Warning
If an RPS is not connected to the switch, install an RPS connector cover on the
back of the switch.
1 Cable guide screw
40
41
42
43
44
45
46
47
48
47X
48X
97925
Catalyst 3560
SERIES
PoE-48
1
2
3
4
1
To Next Page
Loading...
