3-19
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 3 Switch Installation
Installing the Switch
Mounting the Switch in a Rack
After the brackets are attached to the switch, use the four supplied number-12
Phillips machine screws to securely attach the brackets to the rack, as shown in
Figure 3-9.
Figure 3-9 Mounting the Catalyst 3560 Switch in a Rack
After the switch is mounted in the rack, you need to do these tasks to complete the
installation:
• Power on the switch. See the “Powering On the Switch” section on page 1-3.
• Connect to a 10/100 port and run Express Setup. See the “Starting Express
Setup” section on page 1-4.
• Connect to the front-panel ports. See the “Connecting to the 10/100 Ports”
section on page 3-29 and the “Connecting to SFP Modules” section on
page 3-32 to complete the installation.
For configuration instructions about using the CLI setup program, go to
Appendix C, “Configuring the Switch with the CLI-Based Setup Program.”
1 Phillips machine screws
Catalyst 3560
SERIES
PoE-48
SYST
RPS
STAT
DUPLX
SPEED
PoE
MODE
1
2
3
4
1
2
5
6
7
8
9
10
11
12
13
14
15 16
3
4
1X
2X
15X
16X
17
18
21
22
23
24
25
26
27
28
29
30
31
32
19
20
17X
18X
31X
32X
33
34
37
38
39
40
41
42
43 44
45
46
47
48
35
36
33X
34X
47X
48X
97923
1
To Next Page
Loading...
