Chapter 2 Product Overview
Front Panel Description
2-4
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Figure 2-2 Catalyst 3560-48PS Switch Front Panel
10/100 Ports
You can set the 10/100 ports on the Catalyst 3560 switches to operate in any
combination of half duplex, full duplex, 10 Mbps, or 100 Mbps. You can also set
these ports for speed and duplex autonegotiation, in compliance with
IEEE 802.3AB. (The default setting is autonegotiate.) When set for
autonegotiation, the port senses the speed and duplex settings of the attached
device and advertises its own capabilities. If the connected device also supports
autonegotiation, the switch port negotiates the best connection (that is, the fastest
line speed that both devices support and full-duplex transmission if the attached
device supports it) and configures itself accordingly. In all cases, the attached
device must be within 328 feet (100 meters).
Warning
Voltages that present a shock hazard may exist on Power over Ethernet (PoE)
circuits if interconnections are made using uninsulated exposed metal
contacts, conductors, or terminals. Avoid using such interconnection methods,
unless the exposed metal parts are located within a restricted access location
and users and service people who are authorized within the restricted access
location are made aware of the hazard. A restricted access area can be
accessed only through the use of a special tool, lock and key or other means of
security.
1 10/100 ports 2 SFP module slots
97911
2
1
Catalyst 3560
S
E
R
I
E
S
PoE-48
SY
ST
RPS
STA
T
D
UPL
X
SPEED
PoE
MODE
1
2
5
6
7
8
9
10
11
12
13
14
15
16
3
4
1X
2X
15X
16X
17
18
21
22
23
24
25
26
27
28
29
30
31
3
2
19
20
17X
18X
31X
32X
33
3
4
37
38
39
40
41
42
43
44
45
46
47
4
8
35
36
33X
34X
47X
48X
1
2
3
4
To Next Page
Loading...
