3-3
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 3 Switch Installation
Preparing for Installation
Warning
The plug-socket combination must be accessible at all times, because it serves
as the main disconnecting device.
Warning
This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use.
Warning
When installing or replacing the unit, the ground connection must always be
made first and disconnected last.
Warning
To prevent the switch from overheating, do not operate it in an area that
exceeds the maximum recommended ambient temperature of 113°F (45°C). To
prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around
the ventilation openings.
Warning
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations
Warning
If a redundant power system (RPS) is not connected to the switch, install an RPS
connector cover on the back of the switch.
To Next Page
Loading...
