Chapter 3 Switch Installation
Installing and Removing SFP Modules
3-26
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
To insert an SFP module into the module slot, follow these steps:
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on
the chassis.
Step 2 Find the send (TX) and receive (RX) markings that identify the top side of the SFP
module.
Note On some SFP modules, the send and receive (TX and RX) markings might
be replaced by arrows that show the direction of the connection, either
send or receive (TX or RX).
Step 3 Align the SFP module in front of the slot opening.
Step 4 Insert the SFP module into the slot until you feel the connector on the module snap
into place in the rear of the slot.
Figure 3-15 Installing an SFP Module into an SFP Module Slot
Step 5 For fiber-optic SFP modules, remove the dust plugs from the optical ports, and
store them for later use.
40
41
42
43
44
45
46
47
48
47X
48X
Catalyst 3560
SERIES
PoE-48
1
2
3
4
97928
To Next Page
Loading...
