Name: Cisco Catalyst 3650
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

CHAPTER

2-1

Catalyst 3650 Switch Hardware Installation Guide

OL-29734-01

Switch Installation

This chapter describes how to install and connect a Catalyst 3650 switch. It also includes planning and

cabling considerations for stacking switches. Read the topics and perform the procedures in this order:

• Preparing for Installation, page 2-1

• Planning a Switch Data Stack, page 2-5

• Installing the Switch, page 2-9

• Connecting to the StackWise Ports, page 2-15

• Connecting Devices to the Ethernet Ports, page 2-19

• Where to Go Next, page 2-22

For initial switch setup, how to assign the switch IP address, and for powering information, see the

switch getting started guide on Cisco.com.

Preparing for Installation

• Safety Warnings, page 2-1

• Installation Guidelines, page 2-3

• Tools and Equipment, page 2-4

Safety Warnings

This section includes the basic installation caution and warning statements. Translations of the warning

statements appear in the Regulatory Compliance and Safety Information for the Catalyst 3650 Switch

document available at Cisco.com. Read this section before you start the installation procedure.

Warning

Before working on equipment that is connected to power lines, remove jewelry (including rings,

necklaces, and watches). Metal objects will heat up when connected to power and ground and can

cause serious burns or weld the metal object to the terminals.

Statement 43

Warning

Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury

and equipment damage.

Statement 48

Other manuals for Cisco Catalyst 3650

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 3650 and is the answer not in the manual?

General