Cisco Catalyst 3650 - After Installing the Switch; Table- or Shelf-Mounting

2-14
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
Chapter 2 Switch Installation
Installing the Switch
Table- or Shelf-Mounting
To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis (see Figure 2-11).
Figure 2-11 Attaching the Adhesive Pads for Table- or Shelf-Mounting
When you complete the switch installation, see the “After Installing the Switch” section on page 2-14
for more information about the switch configuration.
After Installing the Switch
After the switch is installed, you might need to:
• Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
• Use the CLI setup program to enter the initial switch configuration.
• Connect to the front-panel ports. See the “Connecting Devices to the Ethernet Ports” section on
page 2-19.
1 Adhesive pads
1
1
347793
P
W
R
-C2-6
40WA
C
P
W
R
-C2-640
WA
C
CONSOLE
MGMT