1-13
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
Chapter 1 Product Overview
Front Panel
Note If you insert an SFP+ module in an SFP module slot, the SFP+ module slot does not operate, and the
switch logs an error message. SFP modules can operate in SFP+ module slots.
SFP, SFP+ and QSFP+ Modules
The SFP and SFP+ modules provide copper or fiber-optic connections to other devices. These
transceiver modules are field replaceable, and provide the uplink interfaces when installed in an SFP
module slot. The SFP modules have LC connectors for fiber-optic connections or RJ-45 connectors for
copper connections.
Use only Cisco SFP and SFP+ modules on the switch. For the latest information about supported
SFP/SFP+ modules, refer to the Cisco Transceiver Modules Compatibility Matrix documentation at:
http://www.cisco.com/en/US/products/hw/modules/ps5455/products_device_support_tables_list.html
The 40-Gigabit QSFP+ transceiver module is a hot-swappable, parallel fiber-optical module with four
independent optical transmit and receive channels. These channels can terminate in another 40-Gigabit
QSFP+ transceiver, or the channels can be broken out to four separate 10-Gigabit SFP+ transceivers.
For information on the 40-Gigabit QSFP+ module, refer to the documentation at:
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/transceiver_modules/installation/note/OL_2
4862.html?referring_site=RE&pos=2&page=http://www.cisco.com/c/en/us/td/docs/interfaces_modules
/transceiver_modules/compatibility/matrix/40GE_Tx_Matrix.html
LEDs
You can use the switch LEDs to monitor switch activity and its performance. Figure 1-6 shows the switch
LEDs and the Mode button that you use to select a port mode.
To Next Page
Loading...
