EasyManuals Logo

Cisco Catalyst 9300 Series Hardware Installation Guide

Cisco Catalyst 9300 Series
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
To prevent corrosion, remove or minimize the presence of dust and particulates at the installation site by
following the guidelines mentioned in ANSI 71-04-2013 regulations.
Figure 16: A PCB with Corrosion on its Metal Contacts
EMI and Radio Frequency Interference
Electro-Magnetic interference (EMI) and radio frequency interference (RFI) from a system can adversely
affect devices such as radio and television (TV) receivers operating near the system. Radio frequencies
emanating from a system can also interfere with cordless and low-power telephones. Conversely, RFI from
high-power telephones can cause spurious characters to appear on the system monitor. RFI is defined as any
EMI with a frequency above 10 kilohertz (kHz). This type of interference can travel from the system to other
devices through the power cable and power source, or through the air in the form of transmitted radio waves.
The Federal Communications Commission (FCC) publishes specific regulations to limit the amount of EMI
and RFI emitted by computing equipment. Each system meets these FCC regulations. To reduce the possibility
of EMI and RFI, follow these guidelines:
Always operate the system with the chassis covers installed.
Ensure that all chassis slots are covered by a metal filler bracket and that an unused power supply bay
has a metal cover plate installed.
Ensure that the screws on all peripheral cable connectors are securely fastened to their corresponding
connectors on the back of the chassis.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
38
Preparing for Installation
EMI and Radio Frequency Interference

Table of Contents

Other manuals for Cisco Catalyst 9300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 9300 Series and is the answer not in the manual?

Cisco Catalyst 9300 Series Specifications

General IconGeneral
Operating SystemCisco IOS XE
ModelCisco Catalyst 9300 Series
Uplink Interfaces10G, 25G, 40G
Downlink Interfaces1G
Stacking Bandwidth480 Gbps
Power SupplyRedundant power supplies
PoEUPOE
Port DensityUp to 48 ports
Power over Ethernet (PoE)UPOE, UPOE+
Security FeaturesMACsec
ManagementCisco DNA Center, CLI, SNMP
RedundancyStacking, redundant power supplies, hot-swappable fans

Related product manuals