Cisco Catalyst 9300 Series Hardware Installation Guide

C9300-NM-2Y Module
Table 26: C9300-NM-2Y Module with 25G SFP28 Module
ActionInterface
Configure this interfaceTwentyFiveGigabitEthernet1/1/1
Configure this interfaceTwentyFiveGigabitEthernet1/1/2
C9300-NM-8X Module
All ports in the C9300-NM-8X module default to 10 G and should be configured as TenGigabitEthernet1/1/1
through TenGigabitEthernet1/1/8, even when you are operating them as 1 G using SFP.
Table 27: C9300-NM-8-10X Module
ActionInterface
Configure this interfaceTenGigabitEthernet1/1/1
Configure this interfaceTenGigabitEthernet1/1/2
Configure this interfaceTenGigabitEthernet1/1/3
Configure this interfaceTenGigabitEthernet1/1/4
Configure this interfaceTenGigabitEthernet1/1/5
Configure this interfaceTenGigabitEthernet1/1/6
Configure this interfaceTenGigabitEthernet1/1/7
Configure this interfaceTenGigabitEthernet1/1/8
C9300X-NM-2C Module
Table 28: C9300X-NM-2C Module
ActionInterface
Configure this interfaceHundredGigE1/1/1
Configure this interfaceHundredGigE1/1/2
C9300X-NM-4C Module
Table 29: C9300X-NM-4C Module
ActionInterface
Configure this interfaceHundredGigE1/1/1
Configure this interfaceHundredGigE1/1/2
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
74
Installing a Network Module
C9300-NM-2Y Module

Cisco Catalyst 9300 Series Specifications

General

Operating System	Cisco IOS XE
Model	Cisco Catalyst 9300 Series
Uplink Interfaces	10G, 25G, 40G
Downlink Interfaces	1G
Stacking Bandwidth	480 Gbps
Power Supply	Redundant power supplies
PoE	UPOE
Port Density	Up to 48 ports
Power over Ethernet (PoE)	UPOE, UPOE+
Security Features	MACsec
Management	Cisco DNA Center, CLI, SNMP
Redundancy	Stacking, redundant power supplies, hot-swappable fans