EasyManuals Logo

Cisco Catalyst 9300 Series Hardware Installation Guide

Cisco Catalyst 9300 Series
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
DescriptionNetwork Module
This module has eight Multigigabit Ethernet (mGig) module slots.C9300X-NM-8M
3
This module has eight 25 GE/10 GE/1 GE slots with an SFP28 port in each slot.C9300X-NM-8Y
2, on
page 68
This is a blank module.C9300X-NM-BLANK
1. Supported only on Cisco Catalyst 9300 Series Switches.
2. Supported only on Cisco Catalyst 9300X Series Switches.
3. Supported only on C9300X-24Y.
Note
Installing a Network Module in the Switch
Safety Warnings
This section includes the installation cautions and warnings. Translations of the safety warnings are available
in the Regulatory Compliance and Safety Information for Cisco Catalyst 9300 Series Switches.
Read this section before you install a network module.
Proper ESD protection is required whenever you handle equipment. Installation and maintenance personnel
should be properly grounded by grounding straps to eliminate the risk of ESD damage to the equipment.
Equipment is subject to ESD damage whenever you remove it.
Caution
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could
constitute an energy hazard. Statement 206
Warning
Installing a Network Module
The switch can operate without a network module, but a blank module (with no ports or SFP slots) is available
and should be installed when uplink ports are not required.
Note
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
68
Installing a Network Module
Installing a Network Module in the Switch

Table of Contents

Other manuals for Cisco Catalyst 9300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 9300 Series and is the answer not in the manual?

Cisco Catalyst 9300 Series Specifications

General IconGeneral
Operating SystemCisco IOS XE
ModelCisco Catalyst 9300 Series
Uplink Interfaces10G, 25G, 40G
Downlink Interfaces1G
Stacking Bandwidth480 Gbps
Power SupplyRedundant power supplies
PoEUPOE
Port DensityUp to 48 ports
Power over Ethernet (PoE)UPOE, UPOE+
Security FeaturesMACsec
ManagementCisco DNA Center, CLI, SNMP
RedundancyStacking, redundant power supplies, hot-swappable fans

Related product manuals