Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles
on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the
weight of the unit. Statement 1032
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when
servicing. Statement 1034
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations. Statement 1045
Warning
When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
The process of installing the switch can be broken down into a series of tasks as shown in the following figure:
This section illustrates the installation of a Catalyst 9407R Switch switch. All Cisco Catalyst 9400 Series
Switches are installed in the equipment rack the same way.
Note
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
44
Installing the Switch
Installation Tasks