4-24
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Re manufacturing a CDE
Step 5 Log into VDS-IS, and run the following command:
#model CDE280-2S10
This command will reload the device automatically.
#model CDE280-2S10
Updating the model will reload the system and erase CDNFS volumes.
Please make sure the system is offline.
Proceed with model update? (y/n) y
%SE-DISK-0-200047: Stopping all services (this may take several minutes) ...
INIT: Switching to runlevel: 4
INIT: Sending processes configured via /etc/inittab the TERM signal
INIT: Sending processes configured via /etc/inittab the KILL signal
Recoverying CDNFS volumes...
CDNFS recovery complete
unmounting /swstore... done
unmounting /sw... done
unmounting /state... done
unmounting /local/local1... done
unmounting /boot... done
stopping MD device md5...mdadm: stopped /dev/md5
done
stopping MD device md4...mdadm: stopped /dev/md4
done
stopping MD device md3...mdadm: stopped /dev/md3
done
stopping MD device md2...mdadm: stopped /dev/md2
done
rebooting now...
Restarting system.
To Next Page
Loading...
