4-23
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Re manufacturing a CDE
Figure 4-15 Rebooting the Server
Step 11
Follow Step 10 to Step 14 from the “Connect to the Console” section on page 4-7 and “Configure
VDS-IS Software” section on page 4-7.
CDE280 Model Migration
CDE280 has 6 sub-prototypes and VDS-IS supports CDE280 prototype migration between those 6
sub-prototypes. This section will explain how to change a CDE280 sub-prototype to another CDE280
sub-prototype.
Note Configuration on CDE280 box will be reserved with only model change to new one after this process.
In addition to that, the external disk will be formatted and no caches contents will be preserved.
The main difference between the 6 sub-prototypes is the drives.
Table 4-5 lists the internal and external drives of each CDE280 sub-prototype.
For example, to migrate from CDE280-2S5 to CDE280-2S10, do the following:
Step 1 Switch off the device by clicking the Power button on the front panel of the device.
Step 2 Pull out all the external drives (24 x 240G SSD) of the device.
Step 3 Push the 24 x 480G SSD drives into the device as the CDE280-2S10 should have the 24 x 480G SSD the
external drive only.
Step 4 Power on the device.
Table 4-5 Internal and External Drives of the CDE280 Sub-prototype
CDE280 Variation Internal Drives External Drives
2H1 480G SSD x 2 600G HDD x 1
2H13 480G SSD x 2 600G HDD x 24
2H26 480G SSD x 2 1200G HDD x 24
2S5 480G SSD x 2 240G SSD x 24
2S10 480G SSD x 2 480G SSD x 24
2S21 480G SSD x 2 960G SSD x 24
To Next Page
Loading...
Need help?
General
